Whynter BWB-2060FDS Bedienerhandbuch PDF herunterladen (Seite 10)

Operation and Controls

NOTE: If the appliance is unplugged, encounter power interruption, or turned off, you must wait 3 -5 minutes

before restarting the appliance. If attempted to restart before this time delay, the appliance may not start.

SETTING THE TEMPERATURE CONTROL

• During normal operation, the temperature display on the control panel shows the temperature inside the

appliance.

• This refrigerator has two separate temperature zones.

For the beverage refrigerator zone (left), the temperature range can be set between 36ºF - 43ºF / 2ºC -

6ºC. For the wine refrigerator zone (right), the temperature range can be set between 40ºF - 65ºF / 5ºC

-18ºC

• When the unit is plugged in for the first time, the unit will power up automatically to the preset defaults. The

preset temperature for the beverage refrigerator zone (left) is 38ºF (3ºC) and for the wine refrigerator zone

is 54ºF (12ºC).

• You can press the left zone UP and DOWN buttons to control the internal temperature of the beverage

refrigerator zone and press the right zone UP and DOWN buttons to control the internal temperature of the

wine refrigerator zone.

• The temperature that you desire to set will increase 1ºC or 1ºF if you press the UP button once and will

decrease 1ºC or 1ºF if you press the DOWN button once. The display flashes while you make the setting.

• After the temperature has been set, the display will flash four times before it shows the current internal

temperature of the particular temperature zone.

• To view the set temperature at any time, press the UP or DOWN button, the set temperature will

temporarily ﬂash in the display for 5 seconds. Then the display shows the current internal temperature

again.

TEMPERATURE MEMORY FUNCTION

In the event of a power interruption (power surge, breaker switch, etc.), the unit can remember the previous

temperature settings. When the power has restored, the temperature display will show the current cabinet

temperature.

INTERIOR LIGHT

The interior light makes it easy to view your refrigerator contents. The light can be turned on or off using the

light button on the display.

CABINET SHELVES

NOTE: Do not cover any part of the shelves with aluminum foil or any other material that will prevent adequate

air circulation within the cabinet.

• This appliance is equipped with removable shelves. To prevent damage to the door gasket, make sure the

doors are opened completely before pulling the shelves out.

• For easy content access, you must pull the shelves approximately ⅓ out of the railing.

• The shelves are designed with an emergency stop to prevent them being removed too far when loaded.

• When removing the shelves out of the railing, make sure to remove all items first.

• To remove the shelves, pull the shelf forward until the notch aligns with the plastic post. Lift the shelf and

continue to pull the shelf forward until it is completely removed from the internal compartment.

NORMAL SOUNDS

The unit is cooled by a compressor. The compressor pumps coolant through the cooling system, producing

operating noise. Even when the compressor cuts out, noises caused by changes in temperature and pressure are

unavoidable. Operating noise will be most audible immediately after the compressor comes on. It be-comes

quieter as the operating period continues.

• The following noises are normal and occur from time to time:

• Gurgling sound, caused by the refrigerant flowing through the appliance’s coils,

• Humming noise made by the compressor. This noise can get louder for brief periods when the motor is

switching on.

• Cracking/popping sounds, resulting from the materials contraction and expansion due to temperature

variations

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Kommentare zu diesen Handbüchern

Keine Kommentare

Whynter BWB-2060FDS Bedienerhandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Weinkühler Whynter BWB-2060FDS